Print on paper and in 3D
On paper
Section titled “On paper”Print… (⌘P on the Mac, the More menu elsewhere) opens a sheet with the page and the choices (side by side on the Mac, the page above the choices elsewhere), before the system print dialog:
- Picture: the 3D View exactly as you turned it (when you print from 3D), or the Map.
- On the picture: Paths and areas, Spots, Slope, Contours.
- On the Page: Elevation profile, Numbers, Points, All shapes, Spot list and, under a 3D picture, a Location map.
Each choice appears only when the document has something for it: Slope and Contours for a selected area, the profile for a path, the spot switches when there are spots.

The page updates as you change the choices. Print… goes on to the system print dialog, and Save PDF… keeps the page as a file instead. The choices are remembered, except the picture and the layers, which start as the screen shows them. File ▸ Export ▸ Report (PDF)… on the Mac (More ▸ Export ▸ Report (PDF)… elsewhere) saves the same page with the choices you used last.
What is on the page
Section titled “What is on the page”The page is US Letter where your region measures in US units, A4 elsewhere, and runs over as many pages as it needs:
- The title: the document’s name, the selected shape’s name under it, and the app’s icon at the top right.
- The picture: the map, or the 3D view drawn again on white at print resolution with a caption (the vertical exaggeration, slope, the contour spacing). With Slope on, a legend under it gives the share of the area in each band.
- The numbers, in two columns between two rules.
- Elevation Profile, for a path: the chart drawn as lines, sharp at any size, with distance and height on its axes in the document’s units, and the line of sight when it is on.
- Location: under a 3D picture, the map of where it is.
- Points, for a path or an area: a table with #, Latitude, Longitude, Degrees, minutes, seconds and Elevation.
- Shapes, when the document has more than one: Shape, Kind, Value and Detail (a path’s climb, an area’s range of heights).
- Spots, in the same columns as the points.
- The footer on every page: ObjectGraph, Geo Elevation and its page on objectgraph.com, the date and time it was printed, and “Page 1 of 3” when there is more than one page.
The numbers go further than the panel:
- A path: distance, lowest, highest, climb, descent, average grade and steepest 100 m; with its line of sight on, Line of sight (In sight, Out of sight, a close call or Can’t tell), Clearance, Eye above the start and Height at the end; the number of samples, and the data source.
- An area or a circle: area, perimeter, lowest, highest, relief, mean height, mean slope, steepest slope and the data source.
When the profile crosses the sea, the source carries the credit “Coastline © OpenStreetMap contributors”. Hidden shapes are not printed, and a circle’s view stays on the screen.
Export ▸ 3D Print (STL)… (File ▸ Export on the Mac, ⌥⌘P; More ▸ Export elsewhere; or Export in the 3D view) opens the Print in 3D sheet, which saves the ground as an STL file for a 3D printer:
- For an area, the ground inside it, cut to its outline, on a flat base.
- For a path, the ground around it as a block, with the path raised on it.

Choose the Size of the longest side (100, 150, 200 or 250 mm), the Base (2, 4 or 8 mm), the Height stretch, and whether to Raise the paths; the sheet shows the print’s size in millimeters as you choose. Save STL… writes the file.

